I finally fixed my fading blade issue after 4 months of guessing

For the longest time my clipper blades would start fading after just a few cuts, no matter how much I oiled them. I thought it was the brand or my technique, so I wasted about $80 on new clippers and blades. Turns out the problem was a tiny burr on the clipper lever that was causing uneven tension. It took me about 3 hours across two weekends to file it down and get consistent results again. Has anyone else dealt with a random mechanical hiccup that fooled you for way too long?

3 comments

3 Comments

jordan_henderson139d ago

Man that lever burr is a killer. I spent two months and roughly $60 on replacement blades and different oil brands before I finally noticed a tiny rough spot on the lever pivot pin on my Andis Master. It was barely visible unless you angled it right under a lamp. I used a fine file and some 800 grit sandpaper, took maybe 45 minutes to smooth it out completely. Now the tension is dead even and my blades last like they should. Feels ridiculous when the fix is that small after all that time and money.

jordan_henderson139d ago

File and sandpaper? That's wild, never thought to try that.

fiona_kim979d ago

Man I used to swear it was always the blade gap or my oiling routine causing fading issues. I was dead set on buying better quality metal until I found a microscopic nick on my clipper blade itself that was catching the hair. Felt real stupid after spending a month blaming everything else. Now I check every single part with a magnifying glass before I touch the adjustment screws.