That "harmless" splice I saw a helper do in a Kent attic, 3 months later the whole line failed
Last week I got called back to a house in Kent because the internet kept dropping every time the wind blew. I crawled up in that attic and found the exact splice I watched a new helper make three months ago. He had used a cheap twist-on connector on a coax line instead of a proper compression fitting, and he told me it was fine because it "tested good on the meter." I didn't push it at the time because we were behind schedule and the homeowner was watching. When I pulled the connector off, the copper center was green and the shield braid was barely touching. The signal loss was so bad the modem was dropping channels left and right. The homeowner had already called the provider twice and they charged him for two truck rolls. I felt sick about it because I should have made him redo it right then. Now I check every helper's splices before we roll out, no exceptions. What do you guys do when a helper cuts a corner right in front of you and the schedule is already tight?