avery_flores•2d agoProlific Poster

I finally hit 100 custom cabinet doors without a single reject

I've been building cabinets for 5 years now and last week I finished my 100th door without the client sending one back. That's huge for me because I used to screw up at least 3 or 4 per job. I'm using a Shaper Origin now for the joinery and it's made a massive difference in consistency. Has anyone else seen their reject rate drop after switching to a CNC setup?

3 comments

3 Comments

zara_sanchez2d ago

Shaper Origin changed my game too. Went from 2-3 screw ups per batch to maybe 1 in 50.

the_claire2d ago

Shaper Origin basically makes you look like you know what you're doing even on bad days.

sarahpark2d ago

Woah wait, TWO to THREE screw ups PER BATCH down to ONE in FIFTY?? That's a HUGE drop. I had NO idea the Origin was THAT consistent. My jaw actually dropped reading that number. You're telling me you went from basically ruining stuff every other time to almost never messing up? That's seriously impressive, I always thought it was more about the fancy look than the actual results.