Loading…
24
Bought a $140 laser level that couldn't handle shop dust, back to string lines
I figured a fancy laser would speed up my panel alignment work, but after about 3 weeks in my shop the dust just killed the sensor. The thing started throwing lines off by a quarter inch and I didn't trust it anymore. Took it apart, cleaned the lens twice, still acted up. Has anyone else had laser tools crap out on them in a dusty environment, or did I just get a bad unit?
2 comments
Log in to join the discussion
Log In2 Comments
bailey.jennifer2mo ago
So you blew it out with a compressor and it actually fixed the sensor for good? That feels like it would just push the dust deeper into the housing.
7
wendy_lee482mo ago
Used to have the same problem with mine. What finally worked was getting a compressor and blowing it out every couple days before it got bad. Also started keeping it in a ziplock bag when not in use, even during the day on lunch break. Bit of a hassle but the thing lasted another year after that. Probably should just get a cheaper backup to rotate if your shop is that dusty.
3